James-loudspeaker DSP4/DSP30 Bedienungsanleitung PDF herunterladen

PROGRAMMING THE DSP4/DSP30

NOTE

All DSP4s and DSP30s are custom programmed for your system at James before they are shipped. The

following procedure should only be used if James has instructed you to change the programming or you

believe you need to make changes to your system.

If this was emailed, you will find attached a new DSP config file which will need to be uploaded to the DSP4 or

DSP30.

CABLES/ADAPTERS

To program the DSP, you will need a serial connection from your computer. Some desktops, and many laptops, do

not have serial connections any more, so you may need to buy a USB to SERIAL adapter. This will allow you to use

a USB port on your computer as a serial connection.

SOFTWARE

You will need the QSC Signal manager software. There should be a CD with the DSP, or you can download from:

http://www.qscaudio.com/products/software/signal_manager/signal_manager.htm

PREPARATION

Install the Signal Manager software on your PC. Then save the James supplied config file to the "configurations"

directory normally located in the root of the hard drive at:

C:\Program Files\QSC Audio\Signal Manager\Configurations (I believe it is the same for XP and Vista.)

PROGRAMMING THE DSP

1) The DSP must have power to operate, so it must be physically installed onto the amp or connected to the

optional power supply. Normally, the DSP is programmed while it is installed on the amp.

NOTE: If you are installing the DSP on the amp for the first time, before you install the DSP and cover the

DIP switches, check the DIP switch positions - they should all be switched to the left (off). The limiters,

switch 1 and 10 can be turned on (to the right) for added protection.

1 2 3 4

PROGRAMMING THE DSP4/DSP30 1

Inhaltsverzeichnis

Seite 1 - PROGRAMMING THE DSP4/DSP30

PROGRAMMING THE DSP4/DSP30 NOTE All DSP4s and DSP30s are custom programmed for your system at James before they are shipped. The following procedu

Seite 2

PROGRAMMING THE DSP4/DSP30 Page 2 2) Follow the installation directions with the DSP - be make sure the 2 long screws are used to hold it in place - o

Seite 3

PROGRAMMING THE DSP4/DSP30 Page 3 Normally the Receive and Transmit buffers are at maximum, Start by reducing the Receive Buffer and then try to repr

Seite 4

PROGRAMMING THE DSP4/DSP30 Page 4 13) We recommend also adjusting the input gain of the DSP4 by using the “Options” dialog. This is done while you a

Verwandte Modelle: DSP/DSP30

Kommentare zu diesen Handbüchern

Keine Kommentare

James-loudspeaker DSP4/DSP30 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Akustik James-loudspeaker DSP4/DSP30 herunter. James Loudspeaker DSP4/DSP30 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: DSP/DSP30

Kommentare zu diesen Handbüchern